Modbus Poll is a Modbus master simulator designed primarily to help developers of Modbus slave devices or others that want to test and simulate the Modbus protocol. With the multiple document interface you can monitor several Modbus slaves and/or data areas at the same time. For each window you simply specify the Modbus slave ID, function, address, size and poll rate. You can read and write registers and coils from any window. If you want to change a single register, simply double click the value. Or you can change multiple registers/coils. Multiple data formats such as float, double and long with word order swapping are available.
Supported protocol variants:
Modbus RTU
Modbus ASCII
Modbus TCP/IP
Modbus RTU Over TCP/IP
Modbus ASCII Over TCP/IP
Modbus UDP/IP
Modbus RTU Over UDP/IP
Modbus ASCII Over UDP/IP
Supported Modbus Functions:
01: Read coil status
02: Read input status
03: Read holding registers
04: Read input registers
05: Force single coil
06: Preset single register
15: Force multiple coils
16: Preset multiple registers
17: Report slave ID
22: Mask write register
23: Read/Write registers
You check application from their web page.
This is an usefull application from http://www.modbustools.com. Please visit software page for details.
Note: This is not an BQTEK application. This is an only usefull application that we are using.